JKOwners Forum banner
Cancel
Create thread New Garage Forums

Transfer Case 4wd sensor

Jump to Latest
4.5K views 3 replies 3 participants last post by  crusty1007  
#1 · (Edited)
My sensor is stuck in 4Hi. I think it's messing up other areas, but I can not find a part number for it for my '08. Any help out there?

Edit: I looked in the PART pdf I have, and the number is 05083138AA. Does anyone have a supplier for these besides the delarship? Can I just clean it and get it working again?
 
#3 ·
Nope, transfer case moves fine. I get into 4Hi and 4Lo just fine. I've been out a few times with this. I just get a C1014 code (I think that is the number) saying the sensor is stuck in 4Hi.
 
C
#4 ·
What happens when you unplug the switch from the harness?

Its a 5 position switch & 4 positions are used. It changes the resistance sensed by the computer depending on location of the "plunger".

The sensor is the same from '03-'06 Rubicons & all JK's Rubi & non-Rubi...
We tested a bunch of them from the different years & didn't find any difference if I remember correctly. Its been a while though.
 
Save
Reply Quote Like Like
JKOwners Forum
posts
2M
members
65K
Since
2007
A forum community dedicated to Jeep Wrangler JK owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, reviews, engine swaps, troubleshooting, suspension, and more!
Full Forum Listing
Explore Our Forums
Modified JK Tech Dept. JK General Discussions New Member Introductions Stock JK Tech Dept. Electrical & Lighting Tech Dept.