JKOwners Forum banner
1 - 5 of 5 Posts

·
Premium Member
Joined
·
1,818 Posts
Discussion Starter · #1 ·
I am in the middle of reinforcing my front axle and upgrading axle shafts. Tomorrow, we will install the Mt. Logan Axle Sleeves, and I am upgrading to USA Alloy front shafts.

When I pulled out my stock front shafts, I found these:





I haven't seen any mention of these washer/spacer things on any write-ups. I didn't have them on my TJ D30 stock axles.

Are these necessary, or can I just toss them?

Thanks.
 

·
Registered
Joined
·
453 Posts
Yeah, those just make it easier to install axle shafts without tearing the inner seals.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top