JKOwners Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
55 Posts
Discussion Starter · #1 ·
Considering the Rear and Front elocker override switches, windshield lights, hood bar lights, bumper lights, reverse/offroad lights, etc,,,,,,

I am not able to locate reasonably reachable and visible location on the JK Rubicon dashboard/console area for all those rocker/power switches.....


Your ideas are welcomed and much appreciated.
 

·
Registered
Joined
·
16 Posts
I have an SPOD and i love it. If you do a search on the other board, you will find that while it is expensive at around $400, the customer service, ease of installation, and how clean it looks is well worth in the money in my opinion.

Chuck
 

·
Registered
Joined
·
336 Posts
You might also check Daystar. I've been looking at getting something myself and found a 4 switch set on Quadratec. Made by daystar. The box is 29.99, but you have to buy each switch individually as well, but they're only 13 a piece. Still cheaper then the other set up, but I don't know much about either, just thought I'd share!
 

·
Registered
Joined
·
55 Posts
Discussion Starter · #5 ·
Thanks Swinge86,

I have just found the daystar solution with four switches on quadratec and also on some eBay stores... It solves the 4 switch requirement...

Cheers:D:D
 

·
Registered
Joined
·
61 Posts
Be cautous with the daystar toggle switch mount. If you have a stick shift (manual tranny) It is a very poor design. You will regret it. They make good products, just very poor design
 

·
Registered
Joined
·
336 Posts
Thanks Swinge86,

I have just found the daystar solution with four switches on quadratec and also on some eBay stores... It solves the 4 switch requirement...

Cheers:D:D
Anytime khaiwi! :beer:

Might want to be careful if you have a standard with that switch set-up though... people have been saying that the rubber boot hits the switches... if you're auto, you're fine. :D
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top