JKOwners Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter #1
Is the plunger on a rubi D44 factory housing/locker needed for a non rubicon install? Nothing plugs into it but I wasn’t sure if it was still an integral part of locking the diff.
 

·
Registered
Joined
·
1,886 Posts
I assume you are going to install a Rubi axle into a non-Rubi JK, and supply it with switched 12v to the locker actuator. Correct?

In that case, the plunger, (locked/unlocked sensor), serves no purpose, and is not needed for the locker to function.
 
1 - 2 of 2 Posts
Top