JKOwners Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
888 Posts
Discussion Starter · #1 ·
Looks like it's water pump time, I'm picking it up today, and planing on replacing it in the next day or so, just wondering if there are any tricks/issues I should know about, looks pretty straight forward, only question I may have is removing the pulley

Thanks
 

·
Registered
Joined
·
78 Posts
Loosen but do not remove the 3 bolts that hold the pulley on the pump before removing the belt.
-Remove belt
-Remove bolts for water pump
-Clean gasket surfaces
-Install new pump and gasket
-Install pulley and bolts finger tight
-Install belt, tighten 3 pulley bolts
-Fill and bleed cooling system



Sent from my SCH-I500 using Tapatalk
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top