JKOwners Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
97 Posts
Discussion Starter · #1 ·
Guys,

Been trying to fix a damn ARB leak lately and if you read my previous post it looks to be a bearing preload issue so I'll be pulling the locker again to repair it.

Quick question, any need to repack the bearings in grease? I suppose it couldn't hurt but wanted to check. I doesn't seem they get much in the way of lube once they're installed and running. Does anyone repack them when they pull the axles. I've got a Currie D60 back there with the Currie shafts.

Thanks!

Jamie
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top