JKOwners Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
8,647 Posts
I recently bought some tow hooks (thanks terrahawk!) and didn't think I would have much of a problem, until I found the hardware that Chrysler decided to use to hold some of the molding pieces... (they're all plastic 'screws'!!) I know there are plenty of you guys who have taken your bumpers off (seeing how everyone has an aftermarket bumper) so I was going too see if you could help me....

The plastic piece between the bumper and the body... and the piece under 'guard' are giving me real trouble. The plastic 'screws' won't come out. I'm not getting an aftermarket bumper for a while, so I'd like the keep the pieces in tact and useable... anyone have any input/ideas/help.
i used a drywall screw just place it in th cross and screw in a bit then reverses and shell come out :D
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top