JKOwners Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a Rubicon and the sway bar link came off where it attaches to the axle, due to the people who last worked on it leaving off the large washer that holds the bushing in place. The link popped off the bushing.

I am trying to reinstall the bushing into the link, but it is so hard to keep it straight going in because the bushing is rubber. Is it press fit? I am trying to use a C-clamp. Any other suggesting other than removing the whole link from the frame mount?

The bushing is round with "lips" on both ends to seat into the link.

Thanks!
 
1 - 3 of 3 Posts
Top