JKOwners Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
3,051 Posts
I am installing the backbone in a few weeks. No lift and not planning on pulling the axel out. Hopefully it will not be to bad. I already have the EVO viewers and lca skids. Slowly getting her ready for 35s and lift.

Sent from my PG86100 using Tapatalk
You do not have to pull the axle for this kit, not at all.

The pure jeep backbone brace is a great thing to have. I am glad I went that route vs the traditional inner sleeve. Although I did do upper/lower c gussets and control arm skids when I did my install...
 

· Registered
Joined
·
3,051 Posts
I am installing the backbone in a few weeks. No lift and not planning on pulling the axel out. Hopefully it will not be to bad. I already have the EVO viewers and lca skids. Slowly getting her ready for 35s and lift.


Sent from my PG86100 using Tapatalk
That is a D44 correct?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top