JKOwners Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
116 Posts
Discussion Starter · #1 ·
Anyone have experience with either? Does the baking process or cooling process effect spring rate or durability? With paints, which should I look at that will withstand the flexing of the spring?



Manny
 

·
Registered
Joined
·
5,199 Posts
Many springs come powder coated so I don't think heat is an issue, and IIRC powder coating only requires 400°F or so.

If you paint them I would think the trick is to get good adhesion and not have the paint too thick, but I'm only guessing.
 
1 - 3 of 3 Posts
Top