JKOwners Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
46 Posts
Discussion Starter · #1 ·
I'm looking for a solution to mount a 1330 pinion yoke onto the JK Rubicon axles. The flanged setups that I have seen look like they hang out way too far. I want the u-joint centerline to be as close to the diff housing as possible.

Are there any solutions other than the flanged 1310 and flanged 1350 setups like JE REEL offers? Is it possible to install a standard 1330 pinion yoke like the TJ Rubicons use on the JK axles?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top