JKOwners Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
46 Posts
Discussion Starter #1
I'm looking for a solution to mount a 1330 pinion yoke onto the JK Rubicon axles. The flanged setups that I have seen look like they hang out way too far. I want the u-joint centerline to be as close to the diff housing as possible.

Are there any solutions other than the flanged 1310 and flanged 1350 setups like JE REEL offers? Is it possible to install a standard 1330 pinion yoke like the TJ Rubicons use on the JK axles?
 

·
Registered
Joined
·
115 Posts
I do not know alot about the DSs, but if i am understanding you correctly, Tom Woods may be doing what you want already, but they are pricey.
 

·
Registered
Joined
·
46 Posts
Discussion Starter #3
http://4xshaft.com/index.html

Tom Woods pinion flange is nice in that it doesn't hang out too far, but it's still a flange and I prefer a standard yoke that doesn't hang out far either.

Is Tom Woods flange more compact than the JE REEL 1350 flange?
 

·
Registered
Joined
·
46 Posts
Discussion Starter #4
Now this,

is nice and compact. I just don't want to downgrade from the 1330 yoke that I have right now to a 1310.
 
1 - 4 of 4 Posts
Top