JKOwners Forum banner
1 - 2 of 2 Posts

· Vendor
357 Posts
Discussion Starter · #1 ·
A few years back we picked up a robotic welding machine, but because of the limited amount of space in our old shop we never had a chance to get it setup. After moving a few months back we have been slowly getting ready to set it up and start using it.

Here is Clayton's design for how we want to set up the machine:

Starting to get it setup, we welded our table together and now we just need to run power and wire feed:

Marketing Director
Clayton Off Road
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.