Joined
·
5 Posts
I just got the jeep back after having a custom front bumper made. i hope you like it.
http://i179.photobucket.com/albums/w285/SiShootingSchool/11111a.jpg
http://i179.photobucket.com/albums/w285/SiShootingSchool/11111a.jpg
New Custom Bumper
1 - 8 of 8 Posts
Joined
·
5 Posts
yeah there is, i just don't have the money for one yet
Joined
·
38 Posts
Very nice bumper.
I like your wheels (same as mine) are the tires 35's?
What size lift kit do you have?
I like your wheels (same as mine) are the tires 35's?
What size lift kit do you have?
Joined
·
5 Posts
yeah that is a stinger....haha. and i got the superlift 4" kit and 35" bighorns, but not for long
1 - 8 of 8 Posts
Join the discussion
Recommended Reading
-
Adam's 1310 DS broke. What should I get now?
Modified JK Tech Dept.The stubshaft that goes into the double cardan snapped while I was driving on the highway. I do somewhat hard wheeling on 35's. The DS is 3 years old and made for my 3" lift. Should I just get the same thing again? Also, why did it break there of all places? Sent from my ONEPLUS A6013 using...- 7
- 269
-
Control arm adjustments
Modified JK Tech Dept.What’s up guys, just had my alignment done today after putting on my Metalcloak 4.5 Gamechanger, everything with the numbers looks good, however my front driver side spring is bowed and the sway link is pretty angled. That side of the axle is a half inch further out towards the front of the...- 2
- 143
-
SD Axle Swap — 2014 JKUR
Modified JK Tech Dept.First post, but have looked to this forum for years for advice with my jeep. But I need some help for sure this time. I have a set of 2008 SD axles (90% cleaned and prepped what a nightmare that was) I’m swapping into my JKUR. Looking to talk to someone on here that’s done the same for some...- 7
- 214
-
2011 JK 35in tires and sluggish performance
Modified JK Tech Dept.Hey guys, Im just wanting opinions on my jk. I’m running 35s with a 4in lift as a daily driver Interstate and highway mostly but occasional light off-roading. I really want to up the performance and get rid of the sluggish performance. I’ve changed the shift points with the Aev pro cal which was...- 23
- 2K
-
Thoughts on raising rear axle control arm brackets
Modified JK Tech Dept.I've done some searching but I haven't been able to find any specific info related to my potential plan. So with some time on my hands, I've been researching my future plans for my rear axle. I would like to raise the control arm mounts approximately 2" to increase ground clearance, reduce...- 11
- 815
-
Rob50lx · updated
Join now to ask and comment!