JKOwners Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
115 Posts
Discussion Starter #1
Well, it only took 3 months on the rails and a month or two on the bumper, but they are finally done. I now have a great appreciation for those people out there that do this for a living and can see why this stuff is so expensive.
The finish on them is Dupli-Color Bed Liner, a combination of spray and roll on application. I think the sliders are very stout and will hold up nicely. And now the pics....






 

·
Registered
Joined
·
475 Posts
nicely done! time to sit back and have a few. :beer:
 

·
Registered
Joined
·
202 Posts
NICE job! One of these days I am going to break down and buy a MIG welder and plasma cutter so I can start building my own parts.
.
.
 

·
Registered
Joined
·
115 Posts
Discussion Starter #4
Plasma isn't neccessary. Ox-Acetalyen torch and or a 4.5" cut off disk is all you really need. The cut off disk makes the cleanest and most accurate cuts IMHO. A MIG welder is NICE though, thats what i used, but a stik welder is good enough also.
 

·
Registered
Joined
·
115 Posts
Discussion Starter #6
The rear bumper is gonna be a hybrid of the new teraflex and a PJ, with my own little "twist" on the carrier.
 

·
Registered
Joined
·
401 Posts
Amazing what a guy can do with a little steel and welding wire, LOOKS GOOD!:D
 

·
Registered
Joined
·
115 Posts
Discussion Starter #9
1 - 11 of 11 Posts
Top