JKOwners Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
94 Posts
Discussion Starter #1
inalalled the system mounted all the lights ran the power through the firewall to the batt and left the master control under the dash with intentions to use the remote only. I tested the whole thing before final ziptieing and all was good now the remote quit working after one use so I replaced the batt naturally and still no go. Is my remote bad? I did look closely at the circuit board it looks good to me. how do I contact Vision X or get a new remote?
 

·
Registered
Joined
·
94 Posts
Discussion Starter #2
by the way the master controller does still control everything its just in a bad location now.
 
1 - 2 of 2 Posts
Top