JKOwners Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
241 Posts
We have two of the multi-purpose millers in our shop the newest one is the multi-matic 215 is only a couple of months old .
the other is about nine months old and is their dimension 302 , that is the one that I have more experience with .
the smaller one is nice for lighter material and easier to manipulate around the shop , but the 302 has a better burn controllability especially with aluminum , although the small one is faster to change over from mig to tig .
Depending on how you intend to use them I believe that the 215 is a better unit just a little slower and just a little less able to create the desired penetration on heavier stock than the 302 .
I have wanted to try the rebel but just haven't had the opportunity .
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top