JKOwners Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
4,678 Posts
I assume you are talking Dana UD60's as Mopar does not make axles. They are ideally set up for 37's with the 68.5" width. 42's are going to require some pretty low bs wheels. The 17" wheels will fit fine just make sure you are being with the correct back spacing.
 

·
Registered
Joined
·
4,678 Posts
Thats a Dana UD60 with a jeep sticker on it. I hope you didn't pay that much for it as you can get the front and rear set for $10,500. Fusion 4x4 would be the place to go with a kingpin 60 front at 72" WMS
 

·
Registered
Joined
·
4,678 Posts
At night, in the snow with a broken leg while bears were attacking :thefinger:
I wish it was that instead of the mosquito's that ate our asses up on the 15 mile hike back to the highway at midnight. Luckily I only had to hike 10 miles back with parts in from the staging area the next morning.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top