JKOwners Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Has anyone had problems with their rear locker after installing 5.13 gears?
My locker was installed by a "professional shop" and seems to cycle OK
(On / Off) when the Jeep is suspended on the rack, but has issues (remains locked, etc.) once you lower it onto the ground. The Jeep's only got 4,000 miles on it and all the locker functions worked fine prior to the gear swap.
I also noticed that once the rear axle locked, the Jeep wouldn't come out of
4WD (even with the T-Case lever back in the 2-High position).
 

· Registered
Joined
·
4 Posts
Discussion Starter · #3 ·
This sounds like the same issue so I'll forward the link to the shop. Thank you!!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top