[b4tn]

Anyone happen to know the length of the bumpstops that come with the 2.5" Teraflex spring lift? I am putting in my draglink flip this weekend. I have 4" of lift with the TF bumpstops and the instructions state I need a minimum of 3" bumps.

 

[SoK66]

What lift do you have?

 

[b4tn]

I have a frankenlift. RK mid arms, RK 3.5" springs, TF 1" spacers front and rear, TF 2.5" lift bump stops front and rear, and TF brake line drop brackets.

 

[SoK66]

I'd not guess at it. Get the rig on stands, pull the springs & the factory and added bump stops, leave the shocks attached. Slowly raise the axle with two floor jacks until you either run out of shock travel, or something hits the frame, etc. Measure from the upper bum stop tube to the lower bump stop pad. Add 1" (or less, your call) and that's your bump stop length. Ideally you'd do it with the wheels & tires attached, too.

 

[tiltz]

This says the fronts are 2.75" extensions

http://www.quadratec.com/products/16197_1010.htm

And I have a Synergy flipped draglink with the Teraflex 2.5 springs/bumpstops and the draglink barely clears the frame at full flex. You should be fine with your set up. If you do need more up travel you could notch the frame.