Marcus, not familiar with your dash swap, but was the same cluster reused? Isn't there a sentry light that flashes (like every 45 seconds??) on the dash?
LED tail light blinking every 30 seconds or so
I'm perplexed...
My passenger side tail light blinks at about 30 second intervals when the Jeep is sitting. I have the original OEM plugs cut off and the LEDs are soldered on along with an ORO plate light and third brake light. I have removed the resistors and covered the bare wires where they were tapped in and it is still happening.
Any ideas? My next order of business is to get factory plugs soldered back on to the harness or replace the harness completely and use the new plug and play harnesses from PSC just to eliminate a bad ground or connection. All of the lights are working as they should be aside from the blinking.
My passenger side tail light blinks at about 30 second intervals when the Jeep is sitting. I have the original OEM plugs cut off and the LEDs are soldered on along with an ORO plate light and third brake light. I have removed the resistors and covered the bare wires where they were tapped in and it is still happening.
Any ideas? My next order of business is to get factory plugs soldered back on to the harness or replace the harness completely and use the new plug and play harnesses from PSC just to eliminate a bad ground or connection. All of the lights are working as they should be aside from the blinking.
1 - 2 of 31 Posts
So, what is the link between the cluster and the tail lamp? I don't find any other than the TIPM.
1 - 2 of 31 Posts
JKOwners Forum
A forum community dedicated to Jeep Wrangler JK owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, reviews, engine swaps, troubleshooting, suspension, and more!
Full Forum Listing
Top Contributors this Month
View All
Diode Dynamics
26 Replies
Fklein6768
23 Replies
Old Dogger
16 Replies
Recommended Communities
