JKOwners Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
41 Posts
Discussion Starter · #1 ·
Will soon be installing the full river raider skid system in aluminum and I see the instructions call for mounting the oil skid to the engine motor mounts. Does anyone know what the proper torque numbers are when tightening them back up? Much appreciated.
 

·
Registered
Joined
·
1,120 Posts
in the write-up section there is a zip file you can download with all the torque specs.
 

·
Registered
Joined
·
1,983 Posts
I had to weld tabs to the nuts (or buy some with tabs on them) going inside the frame rails... Makes it easy to tighten them and remove them. Saves a couple hours for maladroits like myself in trying to fish a wrench in to hold them. Also, stainless bolts to aluminium to steel makes for an almost impossible removal if you need to get to anything under the skids. I used anti sieze last time.
(things rror doesn't tell you).
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top