JKOwners Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
844 Posts
Discussion Starter · #1 ·
I just got my hydro assist installed and im curious how some of you guys ran the lines. I know PSC instructs to run the lines OVER the trackbar which is what i have now, but i feel running it over the trackbar prevents the line from moving freely especially when the drivers side drops. I originall had it running under the trackbar but i was worried the trackbar could pinch the line against the diff, but besides that it actually seemed like a better route compared to over the trackbar. Im using two 90* fittings on the ram both facing torqards the drivers side. I can post pictures once i get home

Do some of you have pictures of your lines? Im very curious how everyone else did theirs
 

· Gunnery Sergeant USMC (ret)
Joined
·
14,592 Posts
I tried to get a pic but it didnt come out very good. But my hoses come out of the box then loop up to the motor on the radiator fan then go down to the ram. I wrapped the hoses in extra tubing to protect them when rubbing on the fan. Plenty of slack is built in.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top