Hub centric ring ?

3153 Views 7 Replies 6 Participants Last post by frankie945, Jan 23, 2013

frankie945

Discussion Starter · Jan 13, 2013

Anyone know where I can get some rings I've been searching and can't find the size I need. Surly someone has these allied wheels with the currie rj60. Inside dia is 72mm wheel bore is 106mm. Any ideas I can't find this size anywhere.

Sent from my PG86100 using Tapatalk 2

See less See more

Save

1 - 8 of 8 Posts

Goodysgotacuda

· #2 · Jan 13, 2013

Try bora?

http://www.motorsport-tech.com/4DCGI/hub_rings_select.html

If not, I bet they can make some.

Save

frankie945

Discussion Starter · #3 · Jan 13, 2013

Thanks, I seen that site I guess I'll give them a call tomorrow. Was hoping someone else had this issue and knew a place to get some. Ive been running without them but would feel better if I had some on there to lessen the load off the studs some.

Sent from my PG86100 using Tapatalk 2

Save

beedle4

· #4 · Jan 13, 2013

Tire rack, or if you find the size call some tire joints and see if they have that size in stock.

If you know the oe hub/wheel bore let me know and I can see if we have them at work.

Save

Jadmt

· #5 · Jan 14, 2013

frankie945 said:
Thanks, I seen that site I guess I'll give them a call tomorrow. Was hoping someone else had this issue and knew a place to get some. Ive been running without them but would feel better if I had some on there to lessen the load off the studs some.

Sent from my PG86100 using Tapatalk 2

I just had them make me a set. good quality, expensive and 3 week wait. I feel better having them. apparently they only make them when they get several orders.

Save

MotorsportTech

· #6 · Jan 21, 2013

We can custom make hub rings for you. We do custom hub rings about once a month. The reason is we have to tear down the machine and set it up for rings instead of spacers. Give us a call in the office (775.351.1000) and we can check and see if it needs to be a custom size or if it's something we have stocked. FYI. We are going to build rings later this week.

Save

H.I.I.K

· #7 · Jan 21, 2013

Bora by motortech are great quality and they will take care of you if anything goes wrong.
I'm running their 1" 5x5 to 5x4.5 adapters on my jeep.

Sent from my DROIDX using Tapatalk 2

Save

frankie945

Discussion Starter · #8 · Jan 23, 2013

MotorsportTech said:
We can custom make hub rings for you. We do custom hub rings about once a month. The reason is we have to tear down the machine and set it up for rings instead of spacers. Give us a call in the office (775.351.1000) and we can check and see if it needs to be a custom size or if it's something we have stocked. FYI. We are going to build rings later this week.

Thanks for the offer. I actually have one in the works right now. Waiting on a warmer day to take tire off and test fit it. If they don't work I'll give u a call for sure.

Sent from my PG86100 using Tapatalk 2

Save

1 - 8 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month