JKOwners Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
858 Posts
Discussion Starter #1
This HI-LIFT jack mount attaches to the factory roll cage.
It is an extremely strong and secure way to carry your HI-LIFT
The kit includes:

2 3/16'' thick steel bed-liner coated brackets that bolt to the cage
1 1/2'' tap to thread the pre existing holes in the roll bar
All stainless steel 1/2'' hardware and wing nuts to attach your
48'' highlift jack.
Works on both 2-4 door wranglers
Also available for TJ's

$65 a set
www.riverraider.com
717 262 3079




www.riverraider.com
 

·
Registered
Joined
·
1,071 Posts
I saw that on JKboard and the first review says the brackets fit great, the hardware though sucks and they went and got new hardware..
 

·
Registered
Joined
·
93 Posts
Crash, how did you "find" this mount if you make it?...unless you aren't the same crash who is the River Raider sponsoring manufacturer over on the JK-Forum??? I find it kind of odd, however, that the crash over there is the River Raider rep and also introduced this product, and all of your posts over here have been about River Raider stuff, but I guess anything can happen.

http://www.jk-forum.com/showthread.php?t=45691

Of course, anyone is welcome to show their products, but why not just come out and say that this is yours?
 

·
Premium Member
Joined
·
3,426 Posts
Crash, how did you "find" this mount if you make it?...unless you aren't the same crash who is the River Raider sponsoring manufacturer over on the JK-Forum??? I find it kind of odd, however, that the crash over there is the River Raider rep and also introduced this product, and all of your posts over here have been about River Raider stuff, but I guess anything can happen.

http://www.jk-forum.com/showthread.php?t=45691

Of course, anyone is welcome to show their products, but why not just come out and say that this is yours?
That's pretty pathetic
 
1 - 7 of 7 Posts
Top