JKOwners Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
66 Posts
Discussion Starter #1
ok here's the problem, I bought this unit from a member on another forum, he didn't have the stock amp so I followed the wiring diagram for the replacement harness for vehicle with amplifier ( front outputs of the AVIC to the rear inputs of the 22 pin connector) and the white & blue wire ( marked remote control) to the back of the unit ( wired remote) with a 3.5 jack. The unit works ( menu, map, etc ) but I got no sound. What am I doing wrong?

that blue/white wire is suppose to power the factory amp, is it connected at the right spot, in the ''wired remote'' ? I checked on AVIC 411 but couldn't find anything...

thanks

JL
 
1 - 1 of 1 Posts
Top