I'm sure it's been covered somewhere, but I'm kinda new here: I couldn't stand it anymore, decided to grease the "sealed" stock tie rod ends, etc...and of course, tore a couple of boots. Any advice on replacement boots or parts?
no problem they are measured by the OD of the TRE at the base and the OD of the tapered shaft at the base. so take some measurements before you head out.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to Jeep Wrangler JK owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, reviews, engine swaps, troubleshooting, suspension, and more!
