JKOwners Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hi everyone my esp/bsa light is on in my 2008 Jeep Wrangler it come on after i drive approximately 20ft. I followed all the procedures that others did and requested and it is still on. I replaced all the wheel sensors, my wheel alignment is perfect, theres a new front end on the truck. I even disconnected the battery for a whole day and still nothing. My clockstring is fine as well. I even took off the j6 fuse and still nothing. Can anyone please help with any other suggestions or know wat else it can be. Thanks
 

·
Registered
Joined
·
216 Posts
Do you have a Rubicon with electronic sway bar disconnect? If so, try unplugging the wire harness from the swaybar controller. Mud/water/crud in there can wreak havoc.
 
1 - 2 of 2 Posts
Top