JKOwners Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,855 Posts
Front ones are dirt cheap from RockKrawler... the rear shouldn't be too hard to make, a round piece of steel with a hole in the middle from what it looks like!

Let me know what you figure out, I need to make some rear ones here soon.
 

·
Registered
Joined
·
1,855 Posts
I've only seen one pop out of the front so far, but they were FT springs. I think you'd be fine with progress rate springs, flex it out and see if they get loose at all, that'll be a good check!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top