Crown King?

1 - 1 of 1 Posts

dougnpj

Registered

Joined Oct 8, 2007

1,237 Posts

Discussion Starter • #1 • Jun 4, 2008

Has anyone done the crown king run lately? I have heard everything from you cant do it with out lockers and huge lift to its not that bad? I would like to plan a run on fathers day weekend but would like to know what I am getting into?

1 - 1 of 1 Posts

Recommended Reading

AZ winch help (I’ll pay)

USA - Southwest

My winch is a set-screw set up. I want to swap steel for synthetic BUT I can’t figure out how to get the line through the hole. It’s the same brand and weight Rating as the winch. If anyone has had this problem and is in the Phoenix/Tempe area, give me the suggestions but, even better, give...
- 1
- 210
- D
  diver_matt · updated 17 d ago
Anyone have a set of soft top bow brackets 2007-2011?

USA - Southwest

I have a 2009 4 door JK and I can't seem to find my bow brackets. Anyone have a set they're no longer using? I'm in Glendale, AZ.
- 1
- 316
- snipedu1st · updated 18 d ago
Northridge4x4 SLC Grand Opening!

USA - Southwest

Come celebrate with us during the Grand Opening of our newest shop in Salt Lake City Utah! Just like our Open House events, you can take advantage of once a year savings and raffle prizes, free swag and meet our staff. Plus meet some of the amazing people who are responsible for the parts you...
- 1
- 403
- Northridge4x4 · updated 10 mo ago
Tucson Hang Out

USA - Southwest

Tucson Hang Out AKA "Dirty South" I know there is already a AZ thread on here. But most everyone on there is from Phoenix and you know us fucktards down south just have to be special and all. And the fact that I just got banned from that lame site I am going to start a Tucson thread. Say what...
- 17K
- 853K
- Uncle Sams Misguided Child · updated 11 mo ago
Welder needed near Mesa AZ

USA - Southwest

So I was changing out the water pump on my JK 3.8 motor and one of the top water pump bolt broke off in the motor. It’s got a little sticking out (very little). But I am thinking the best way to remove it would be to weld a nut on the end of if. Problem is I can’t weld and have no welder. Can...
- 2
- 521
- B
  burnout88 · updated Mar 18, 2019