JKOwners Forum banner
1 - 10 of 10 Posts

· Registered
Joined
·
13,219 Posts
Discussion Starter · #1 ·
So far I've found a new one for $75 online, anyone buy one recently for cheaper?

Mine has been cracked and I'm sure my milage has suffered due to it. My driver's side fuel trims are about 6% higher than my passenger side, probably due to the crack. :flame:

And yes, I'd prefer to buy RIPPs..just can't swing it now. :(


...because we all like pics

 

· Registered
Joined
·
13,219 Posts
Discussion Starter · #3 ·
Last I checked a tube of high temp epoxy was $6 or so, if that's cheap enough for ya.
Yep, thats what I put on there just because I had some sitting around. Never seen it actually work for a very long period. I'm pretty sure it instantly failed.
 

· Registered
Joined
·
13,219 Posts
Discussion Starter · #5 ·
Drill stop the crack, and clean a place for your ground. Drive around for 5 minutes to get your preheat on the header, weld it, and then drive around for 5 more minutes to get your post heat.
I'd prefer just swapping mine out with yours under the cloak of night...:cwm13:

I might just try welding it, I have nothing to lose really; then I'd have custom exhaust manifolds.
 

· Registered
Joined
·
13,219 Posts
Discussion Starter · #7 ·
Them thar's a justa-flyable o fence round these parts to shoot someone
Are you going to sic your German Shepard on me?

 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top