JKOwners Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a jeep compass limited 2008 and recently i had a problem with abs module which was required to be replaced as per the services center's instruction. So i bought new abs module of which part number is mentioned in center's bill. So i think i bought right parts and replaced it. But i had a flashed light of abs sugnal with high tone of "ding" every few seconds. The module was new ones and i did power cable initialization as per elec. manual by taking off negative and positive and attaching each other for 10 min. and connecting them again. But it is still coming. The abs module is able and required to be reprogramed? Or should i set VIN after installation of abs module? If so, how can i do it? I am in korea but i took the abs module from usa.
 
1 - 1 of 1 Posts
Top