JKOwners Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
199 Posts
Discussion Starter #1
I am going to 1 tons, so I need to sell these first to help fund the project.

2010 Jeep JK Rubicon Dana 44 axles. 20k miles since complete rebuild, front wheel bearings have about 2k miles on them.

Front:
Artec axle truss kit with factory track bar height.
LCA skids
C-gussets
New Timkin wheel bearings
Alloy Ball Joints
Factory E-locker
5.38 G2 ring and pinion with 4WP warranty
Master install kit when installed
Tacked u-joint caps on front shafts
comes with 1 300m RCV shaft. (never bought the other side)
Set up for PSC Hydro assist

Rear:
Atrec truss system
5.38 G2 ring and Pinion with 4WP Warranty
Master install kit when installed
Ten Factory 32 spline chromoly shafts
Factory E-locker

These will be complete with tie rods, brakes, and I will even throw in the factory drive shafts and factory rear shafts.

$4900 plus shipping from 78073 San Antonio, Texas

Serious buyers please call or text for the fastest response. 210-391-5811

I will strap them on a pallet and load them with a forklift to save you some money on shipping.

I will also have 4 black 17" American Eagle wheels for sale after these axles sell. $400 for all 4 of those. They look like the Method Double Standards. 5x5 pattern.
 
1 - 2 of 2 Posts
Top