JKOwners Forum banner

AZ winch help (I’ll pay)

901 views 1 reply 2 participants last post by  Jadmt 
#1 ·
My winch is a set-screw set up. I want to swap steel for synthetic BUT I can’t figure out how to get the line through the hole. It’s the same brand and weight Rating as the winch. If anyone has had this problem and is in the Phoenix/Tempe area, give me the suggestions but, even better, give me a hand. I’ll pay for time/gas.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top