JKOwners Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
6,287 Posts
Discussion Starter #1
might be getting a new camper and i need to get a 7 pin harness installed for it. anyone do one yet? i have the factory tow package now so i think all i nned to do is run a constant and a brake for the 7 pin connector and the brake controller and use the factory wires for turn, stop and park.
 

·
Registered
Joined
·
127 Posts
Easy install. Good instructions, if you understand the MOPAR pictographs... if not you can figure it out.

Bob
 

·
Registered
Joined
·
792 Posts
I think MichaelW did a 7 pin install.
 

·
Registered
Joined
·
6,287 Posts
Discussion Starter #4
got it done. it was easy. just got a new pulg that had 4 and 7 pin hook ups pluged that into my stock 4 pin and ran a accessorie (charges camper battery) and a wire up to the brake controller.
 
1 - 4 of 4 Posts
Top