Adding component speakers

1687 Views 3 Replies 3 Participants Last post by llh11456, Nov 18, 2008

SRTpusher

Discussion Starter · Oct 17, 2008

i am adding some new components into the dash as my stock ones didn't like me blasting them at max volume.

how would i wire in the components to the stock deck with no amp?

would i do it this way -

run wire from stock 6.5 to crossover and run dedicated speaker wire from the crossover to the new tweeter and the new 6.5?

or

would i just put the tweeter on the dash and the 6.5 in the lower dash with no crossover?

Save

1 - 2 of 4 Posts

SRTpusher

Discussion Starter · #3 · Oct 18, 2008

mcnaught6 said:
you should have a single + and - that went into the factory 6.5. take those and run them into the crossover, then run the tweeter and mid separately out of the crossover.

that would be option A - that is what i thought, i just wanted to make sure...

Save

1 - 2 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month