8274?
1 - 2 of 2 Posts
Joined
·
54 Posts
not a warn...built it myself and purpousfully offset the winch to center it..
![]()
not done with it yet gotta cut the fairlead hole..but I know the winch wont quit till I do...:grinpimp:
not done with it yet gotta cut the fairlead hole..but I know the winch wont quit till I do...:grinpimp:
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
How are these JK's able to open the tail gate?
Modified JK Tech Dept.I know these are all drop tail gate conversions but I don't understand how they're opening the tail gate if there is a soft top or roof installed.- 11
- 453
-
Help ID these flares or are they hand cut?
Modified JK Tech Dept.I'd like to find some of these for my 2012 JKU. I know these are on a JL but I was wondering if anyone knows the brand. Thanks in advance for any help. I have searched about everywhere I know to search.- 4
- 207
-
loanwolf2005 · updated
-
Broken ring gear
Modified JK Tech Dept.I recently had a ring gear failure on my Dynatrac prorock XD-60. I found several teeth have cracks in the same location around the ring. Has anyone heard of Dana having defective gears?NH- 6
- 243
-
mud2moab · updated
-
P0300 after installing Centerforce flywheel - SOLVED!
Modified JK Tech Dept.Just wanted to put this information out there for anyone else that might run into this issue. I installed the heavier Centerforce flywheel (700474) in my 2008 JK 3.8L, along with a new Exedy clutch kit (KJP02). I also replaced the rear main seal that had recently started leaking a bit...- 3
- 141
-
mikejwil · updated
-
Jku Half door build
Modified JK Tech Dept.Jku Half door build and snow plow Here's a few pics of my start to this project Sent from my SM-G930V using Tapatalk- 600
- 65K
-
pvanweelden · updated
Join now to ask and comment!