[ALASHA]

Yes Dakota is Dan formally of Burnsville.

Bruiser Conversions is another option.

 

[ALASHA]

That being said I am working on a engine swap in old green and it is not a V8

 

[ALASHA]

Out of curiosity does anyone have a measurement of the length of a 6.4 with an 8hp70 trans and some transfer case? Looking for front of accessory drive to output shaft of the transfer case ideally

 

[ALASHA]

I took a quick measurement from the front of the crank pulley to flange of the transfer case . It’s about 69 inches +/- and inch . I used a tape measure and just pulled it. I’ll try to drop a plum-bob and mark the floor with some tape to get a more accurate measurement.


Sent from my iPhone using Tapatalk

That is prefect. Dont need an exact measurement. This is close enough for me to go figure out if it will work in what I want to put it in.

Thank you very much for measuring that! 🍺 🍺