JKOwners Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
564 Posts
Discussion Starter #1 (Edited)
38x13.50-17 Boggers mounted on Method beadlocks on 2"-2.25" bump stops (2.5" Metalcloak coils), 1.25" Body Lift, Flat flares, and some very mild trimming on the front bumper and rear of the rear wheel opening. Running a 14" stroke shock on the front and an 11" stroke shock on the rear. Plan on getting shock a 12"-13" rear shock.
20190226_174119_1551778813442.jpg 20190226_174508_1551779009482.jpg 20190226_174427_1551779417807.jpg 20190226_174246_1551779569778.jpg
 

·
Registered
Joined
·
564 Posts
Discussion Starter #2
The full width Poison Spyder bumper needed the most trimming. Shaved about 1" off of all of it with a few spots losing 2"-3".

Only had to trim the bottom rear of the rear wheel opening a little bit. I may take a little and go up a little higher to get to full bump(haven't had a chance to check clearance since the initial trim). 20190226_141908_1551779795823.jpg 20190226_135927_1551779671880.jpg 20190305_050140_1551780112137.jpg
 

·
Registered
Joined
·
506 Posts
Looks great! I really miss my boggers but like the lateral traction my km3's give me on side hills and off camber trails.
 
1 - 3 of 3 Posts
Top