JKOwners Forum banner

35x12.50 on stock carrier, stock bumper, NO spacer

2K views 5 replies 4 participants last post by  venom 
#1 ·
little bit of carving
bumper corner was already modded at Katemcy so I figured what the hell
I had already chopped the 3rd brake light down to shine thru the wheel
pics should pretty much tell the tale
 

Attachments

See less See more
5
#4 ·
Innovative. Teraflex has a spacing bracket that they sell for $29.99 for those considering a less labor intensive route.
 
#6 ·
I was looking at the TF bracket, but most of the bracket manufacturers say not to go above a 33" because of the weak sheetmetal on the JK.
I figured not using the bracket, I wouldn't be spacing the tire out and increasing the leverage.
As far as labor, I think it took me about 5 minutes with the angle grinder to do the whole thing.
I basically did it just on a lark so I can carry my spare until I get a real bumper/carrier
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top