JKOwners Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
83 Posts
Discussion Starter · #1 ·
Full-Traction Suspension 2007-2012 Jeep JK Wrangler Long Arm Kit
Do you drive your JK Wrangler daily? Modifying it doesn't mean that it can't ride better than stock. This system offers hard core rockcrawling performance that rides BETTER than stock. Don't believe the hype about radius arms, the arguments being offered are more confusing than revealing. The factory uses a 4 link configuration for several important reasons. Added strength and safety, reduced binding and bushing wear, and incomparable differences in both on and off road driving performance are the proof of this method. Full-Traction has taken the factory 4 link configuration to its limits by adding arm length and geometry corrections to compensate for height, and performance in critical off road conditions. Fully Bolt-On, no welding or exhaust modification required.

Available as:
• FTS7330 - 3.0"
• FTS7340 - 4.0"
• FTS7360 - 6.0"

FULLY BOLT ON - NO WELDING
NO LUBRICATION REQUIRED! Maintenance Free
ABSOLUTELY NOISE FREE - SILENT RIDE!
 

Attachments

·
Registered
Joined
·
83 Posts
Discussion Starter · #2 ·
Please note this a redesign of the JK long arm kit. A couple key changes/features

No replacement cross member included. After market HD Cross member will be available

Cross member skid plate included. Attaches to stock cross member

NO EXHAUST MODS REQUIRED

NO GRINDING OF CUTTING on the new control arm brackets. Fits without modifications

3-4" kits must use 1310 drive shaft

6" kit requires special 1350 drive shafts, available factory direct from us

Kit is works on 07-12 JK's two door and four door
 

·
Registered
Joined
·
83 Posts
Discussion Starter · #4 ·
So you no longer have to cut off the factory brackets? If so that's pretty cool for the DIY type that don't have the tools to install most longarm kits.


Sent from my iPhone 4 using Tapatalk

Sorry for the confusion...

You Need to cut the factory brackets off. What you don't need to do is cut and grind on our brackets. I have received several emails from customers saying other vendors require this to work on the 2012's..

Our goal was no modifications to the factory exhaust...
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top