NOR-CAL SWAP MEET buy/sell/trade - Page 40 - JKowners.com : Jeep Wrangler JK Forum
 10Likes
Reply
 
LinkBack Thread Tools Display Modes
post #976 of 980 Old 02-22-2019, 03:58 PM
JKO Addict!
 
White13JKUR's Avatar
 
Join Date: Oct 2013
Location: Danville, CA
Posts: 2,968
Feedback: 0 reviews
FS; AEV 3.5" SC lift for JKU

Up for sale today is an AEV 3.5” lift for Jeep JK. It is a 4 door kit. On a 2 door, this will probably be a 4.5” or more kit (with 3” bump stops). The kit is complete, except for the AEV ProCal programmer. On my 4 door, this cleared 35” Goodyear MTRs with unmodified, stock fenders. With chopped fenders, I ran 37” MTRs as well as Nitto 37” MTRs.

**SOLD**

Available for pickup in Danville or Santa Clara

Kit is in excellent condition and ready for a new home. It is a great kit on a daily driver and an overlander because of the progressive springs, matched shocks and all of the geometry correction brackets.

The kit includes a few extras as follows:
*Spare set of front knuckles that have been pre-drilled (so you can save your originals without drilling them)
*Both front and rear sway bar links versus just the rears
*Complete drag link versus just the long end
*Rear coil spring wedges


EDIT: Lift has sold. Pics removed.

Last edited by White13JKUR; 02-27-2019 at 07:07 PM.
White13JKUR is offline  
Sponsored Links
Advertisement
 
post #977 of 980 Old 02-24-2019, 04:12 PM
JKO Addict!
 
White13JKUR's Avatar
 
Join Date: Oct 2013
Location: Danville, CA
Posts: 2,968
Feedback: 0 reviews

Deals on new, top quality steering linkage and stabilizer….
Selling it because I went with a completely different setup for one ton axles that have different steering parts.


New Yeti Extreme drag link and tie rod from Steer Smarts. I bolted it on to my jeep and then ordered one ton axles. Otherwise brand new and never driven.

The drag link is for "Top Mount" steering knuckles like Reid Racing.
Includes original instructions/torque specs and stickers.


Brand new Teraflex Falcon Nexus 2.2 Adjustable Steering Stabilizer (1-5/8") that I bought and never installed. It is in perfect condition and includes original instructions and installation hardware. No box.

This stabilizer works with the larger 1-5/8" tie tie rods. The stock Jeep JK tie rod is 1-3/8" diameter.

Local pickup in Danville or in Santa Clara California on weekdays.


****SOLD***

Last edited by White13JKUR; 03-02-2019 at 04:45 PM.
White13JKUR is offline  
post #978 of 980 Old 03-18-2019, 12:33 PM
Wheeler
 
NorCal_redrubi's Avatar
 
Join Date: Feb 2011
Location: Woodland, CA
Posts: 15
Feedback: 0 reviews
FS: Motorsport Tech wheel adapters for Humvee 16.5" beadlocks - Woodland, CA

Set of 4 custom wheel adapters for stock Humvee 16.5" beadlock wheels. In good condition, includes lug nuts and all required hardware.

Convert to 8 on 6.5" bolt pattern, hub and wheel centric, 2.5" thick for 4.5" backspacing with the 7" BS wheels.

1 pair are set up to run with Spyntec hub conversion, 5 on 5.5" bolt pattern and appropriate hub bore.
1 pair are set up for stock JK shafts, 5 on 5" bolt pattern and stock hub bore.

$100 takes one or both pairs.
NorCal_redrubi is offline  
Sponsored Links
Advertisement
 
post #979 of 980 Old 03-18-2019, 12:50 PM
Wheeler
 
NorCal_redrubi's Avatar
 
Join Date: Feb 2011
Location: Woodland, CA
Posts: 15
Feedback: 0 reviews
FS: Rear Dana 44 Superior 35 Spline Axle Shafts - Woodand, CA

1 Pair Dana 44 rear axle shafts from Superior Axle and Gear (when they still existed), 35 spline for use with ARB Locker, drilled for single 5x5 bolt pattern, without bearings/seals/retainers. I ran these for less than 10,000 miles.

$100
NorCal_redrubi is offline  
post #980 of 980 Old 03-18-2019, 01:05 PM
Wheeler
 
NorCal_redrubi's Avatar
 
Join Date: Feb 2011
Location: Woodland, CA
Posts: 15
Feedback: 0 reviews
FS: 2007 4-Door Factory Softop - Woodland, CA

Complete factory soft top from 2007 Unlimited Rubicon. Hardly used for less than 6 months total use out of the 11 years of owning the Jeep, in storage otherwise. It just needs a little cleaning once reinstalled on a vehicle to clear off a little dust/pollen/water spots.

Includes all door surrounds and hardware.
Dark Tinted Windows

$600

Update: Soft top SOLD

Last edited by NorCal_redrubi; 03-26-2019 at 06:35 AM.
NorCal_redrubi is offline  
Sponsored Links
Advertisement
 
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the JKowners.com : Jeep Wrangler JK Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome