Trade 78-79 ford D60's for JK Rubi axles.
Was in the middle of a 1ton Jeep XJ build when I bought my daily driver 4 door JK Sahara, Now I want to build a TRUE rubiclone.
Looking into trading some stuff for JK Rubicon axles, Hoping for close to MA as i dont want to deal with shipping.
Ive got a 78-79 F350 kingpin front HP Dana 60 SRW (the one that everyone over on pirate wants due to lots of room on the short side axletube for coil springs) As of now i have all the parts but its stripped down to the housing, It is missing a brake caliper / locking hub parts, but have all factory shafts, knuckles ect. All factory mounts already removed.
Also for that i have a brand new in box ARB RD36 for the D60 front. I planned to buy some drive flanges, and throw some deeper thick gears in, (ive got 3.55s and 4.10's for this axle)
Ive also got the matching D60 rear axle from the same truck, Also mounts have been removed, all new drum brakes/hardware/ect. Still geared to 4.10's with a LSD. Its a 30 spline axle, but i believe can be bored out pretty easily to accept 35 spine shafts.
Also Ive got a brand new matched set of Dana 60 diff covers for both front and rear axles and hardware.
Not really looking to sell for cash, Just trade for JK rubicon axles. Also may be looking into TJ rubicon front axle for the XJ project. Will throw in cash for the right deal.
Last edited by doesmyaudicount; 02-12-2012 at 07:20 AM.
Reason: Bad wording.