ABS lights on, pulling to the left - JKowners.com : Jeep Wrangler JK Forum
 2Likes
  • 2 Post By rockystock
 
LinkBack Thread Tools Display Modes
post #1 of 8 Old 10-21-2019, 06:57 AM Thread Starter
Rock God
 
upalms's Avatar
 
Join Date: Aug 2009
Location: Connecticut
Posts: 876
Feedback: 0 reviews
ABS lights on, pulling to the left

Would this a bad left sensor or right? I'm thinking left?

Thx

Todd
2007 Unlimited
40 Toyo Open Countrys on Workz Rims
OrFab Rear Bumper, Smittybilt Front
Cree Light Bar
7.5 Long Arm Lift
Synergy Front Suspension
Artec Front JK Armor
5:13's
Tom Woods Drive Shafts
Hi-Lift & Much More
&
2000 TJ
6" lift
37 TOYO MT's on Worx Rims
$hitty Built bumpers
Air Raid
Bushwhacker Flairs & Trail Armour
Corbeau Baja RS seats
upalms is offline  
Sponsored Links
Advertisement
 
post #2 of 8 Old 10-21-2019, 10:08 AM
Granite Guru
 
rockystock's Avatar
 
Join Date: May 2014
Location: Knoxville, TN
Posts: 477
Garage
Feedback: 0 reviews

Go to parts store and read the codes.

Sent from my LG-H910 using Tapatalk
rockystock is offline  
post #3 of 8 Old 10-21-2019, 10:34 AM Thread Starter
Rock God
 
upalms's Avatar
 
Join Date: Aug 2009
Location: Connecticut
Posts: 876
Feedback: 0 reviews

Yeah tried that, but there's no check engine light so it wont pull a code...

Todd
2007 Unlimited
40 Toyo Open Countrys on Workz Rims
OrFab Rear Bumper, Smittybilt Front
Cree Light Bar
7.5 Long Arm Lift
Synergy Front Suspension
Artec Front JK Armor
5:13's
Tom Woods Drive Shafts
Hi-Lift & Much More
&
2000 TJ
6" lift
37 TOYO MT's on Worx Rims
$hitty Built bumpers
Air Raid
Bushwhacker Flairs & Trail Armour
Corbeau Baja RS seats
upalms is offline  
Sponsored Links
Advertisement
 
post #4 of 8 Old 10-21-2019, 10:54 AM
Rock God
 
Join Date: Feb 2015
Posts: 732
Feedback: 0 reviews

Stored codes can be read by star scan if you have access , but I would switch left for right and see if it pulls the other way .

It's an easy task . then purchase two sensors any way they are cheap enough and they are pretty fragile .
Otherwise as soon as you replace one the other fails anyway .
Typical FCA Junk !
un lupus is offline  
post #5 of 8 Old 10-21-2019, 02:31 PM
Gunnery Sergeant USMC (ret)
 
Uncle Sams Misguided Child's Avatar
 
Join Date: Dec 2010
Location: Tucson AZ
Age: 52
Posts: 22,071
Feedback: 8 reviews

My bosch scanner pinpointed it down to the exact sensor when I broke a wire. I didn't have a check engine light on either.

Quote:
Originally Posted by lohchief View Post
If people don't take a stand now,you'll be bitches under their thumbs tomorrow.
Quote:
Originally Posted by StubEXrube View Post
I think too much of a pressure variant between Earth and outer-space... lack of oxygen... something like that.
Uncle Sams Misguided Child is offline  
post #6 of 8 Old 10-21-2019, 07:48 PM
Granite Guru
 
rockystock's Avatar
 
Join Date: May 2014
Location: Knoxville, TN
Posts: 477
Garage
Feedback: 0 reviews

I just replaced my left front sensor. Prior to replacing, Bluedriver showed C1041, "left front tone wheel performance." Check your code before digging in; but if you need to replace the sensor... Changing the sensor is kind of a bitch - I had to take the brake rotor and unit bearing off to get the sensor out from around the brake dust shield. Clean everything and use lots of marine grade anti-seize on the bearing assy mating surfaces, and also the axle shaft splines so it will all come apart easier next time.

Brake caliper mounting bolts: 120 lb ft (21mm socket)
Unit bearing mounting bolts: 75 lb ft (13mm 12-point socket)
Axle shaft nut: 100 lb ft (should not reuse)

Chrysler makes a newer speed sensor that has longer wiring (about a foot, better for articulation): part # 68003281AC.





Sent from my LG-H910 using Tapatalk
Banshee and The old fart like this.

Last edited by rockystock; 10-21-2019 at 08:20 PM.
rockystock is offline  
post #7 of 8 Old 10-22-2019, 08:12 AM Thread Starter
Rock God
 
upalms's Avatar
 
Join Date: Aug 2009
Location: Connecticut
Posts: 876
Feedback: 0 reviews

Thanks for the input guys, yeah I've had the whole front end stripped down before doing the gears and truss/sleves, if I remember correctly I just have to pull the brakes and get the rotor off to get to it, the fun part is the 40x15.5x20 that has to come off first, normally I'd just replace both and be done with it but my week is packed so if I have a shot of figuring out which one is is and fixing it I'll replace the other one in the next few weeks.

Just heard from my buddy has a DRB scanner, going there tomorrow

Todd
2007 Unlimited
40 Toyo Open Countrys on Workz Rims
OrFab Rear Bumper, Smittybilt Front
Cree Light Bar
7.5 Long Arm Lift
Synergy Front Suspension
Artec Front JK Armor
5:13's
Tom Woods Drive Shafts
Hi-Lift & Much More
&
2000 TJ
6" lift
37 TOYO MT's on Worx Rims
$hitty Built bumpers
Air Raid
Bushwhacker Flairs & Trail Armour
Corbeau Baja RS seats
upalms is offline  
post #8 of 8 Old 11-02-2019, 09:39 AM Thread Starter
Rock God
 
upalms's Avatar
 
Join Date: Aug 2009
Location: Connecticut
Posts: 876
Feedback: 0 reviews

my buddy hasn't been able to get here with his scanner, can I just disable the ABS temporarily? I've heard about the J6 and J7 fuses, but of course not clear?

it's a 2007 JKU.

If I could just pull a fuse so I can drive it for a couple days that would be great, one person said pulling the fuse will disable the fuel pump?

Thx

Todd
2007 Unlimited
40 Toyo Open Countrys on Workz Rims
OrFab Rear Bumper, Smittybilt Front
Cree Light Bar
7.5 Long Arm Lift
Synergy Front Suspension
Artec Front JK Armor
5:13's
Tom Woods Drive Shafts
Hi-Lift & Much More
&
2000 TJ
6" lift
37 TOYO MT's on Worx Rims
$hitty Built bumpers
Air Raid
Bushwhacker Flairs & Trail Armour
Corbeau Baja RS seats
upalms is offline  
Sponsored Links
Advertisement
 
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the JKowners.com : Jeep Wrangler JK Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome