When modding our Jeeps, we usually care of the front the most. But the rear is also important, protecting your Jeep Wrangler from different hazards or that distracted driver in the parking lot. Body Armor
created a rugged rear bumper, allowing better ground clearance and departure angles. Equipped with a pair of welded shackles with D-rings for recovery points, it also retains the use of the factory hitch receiver for a third recovery point if necessary.
- Constructed of 3/16” carbon steel
- High clearance design to maximize departure angles
- Dual wheel bearing pivot system
- Swing arm can carry 40” tire, Hi-Lift jack, 2 gas cans
- No-drill, no-weld simple install.
Body Armor Rear Bumper
got your tail covered! Inquire for the prices quotes in the comments below.