JKowners.com : Jeep Wrangler JK Forum - View Single Post - My transfer case linkage fix
View Single Post
post #23 of Old 11-03-2013, 06:09 PM
Stopher
Rock God
 
Stopher's Avatar
 
Join Date: Aug 2010
Location: Hattiesburg, MS
Age: 38
Posts: 969

Pulled the console, found the problem


Engineering FAIL


Trimmed the factory replacement bushing first


Then found this little jewel in the bottom of a bucket. Had to drill it out to 5/16 ID and them used a Dremmel to enlarge the ID of the plastic bushing rather than reduce the OD of the brass.


Used a 3/16" E-clip to keep it locked in place.



It looked like the plastic linkage might slip over the E-clip so I used a washer.


Hope this helps someone else. One of these days I'll do the t-case side.

Side note: why is there untreated metal ANYwhere on a Jeep, notice the rust under the console.

08 "X", RC BB, 33" Duratracs, Coast 1310 front, Hellfires, Woods evap relo.
Stopher is offline  
 
 
For the best viewing experience please update your browser to Google Chrome