JKowners.com : Jeep Wrangler JK Forum - View Single Post - Delta Tech H4 conversion housings and bulbs - Headlight Shootout 2012!
View Single Post
post #9 of Old 09-29-2012, 03:09 PM Thread Starter
Mr.RonGilbert
JKO Addict!
 
Mr.RonGilbert's Avatar
 
Join Date: Feb 2009
Location: Houston
Age: 48
Posts: 9,140
Garage

The Xpel website is very informative, there are tips, videos and good FAQ available so just about anyone can figure out if they can get it done or not. There is also a phone number for tech support for questions that are not found on the website.


Frequently Asked Questions:

Answers to some of the most common installation questions...

Headlamp Protection Products

"I have installed the kit on my headlights and they looked fine, but now they look foggy. Did I do something wrong?"

When using the wet application technique, this is normal. The fog is the result of the alcohol/water solution evaporating from beneath the plastic. The water vapor that is produced results in a hazy appearance for several days. The haze will clear as the vapor dissipates.
"Is it best to apply your light protection kit to the lenses wet or dry?"

We have found that the wet installation yields the best-looking installation with the least amount of difficulty in most cases. On larger headlamp pieces, bubbles and improper alignment of the material are far less likely using the wet installation method. However, on smaller pieces, such as fog lamps, the dry installation method is sometimes easier. This is especially the case if the lamp is spherical in shape.

"The lights on my car are heavily contoured. Is your kit hard to install on this type of light or should I have them professionally installed?"

Our headlamp protection material is extremely pliable and can easily be contoured over dome shaped surfaces. Professional installation should not be necessary provided that you follow the instructions closely. If you still feel uncomfortable attempting installation on your own, check our installer finder for an installer near you.

"I have the headlamp kit almost completely applied using the wet application method, but I can't seem to get the edges to completely stick down. What am I doing wrong?"

It is absolutely imperative that a hairdryer or heat gun is used in this area to seal the edges. The heat serves two purposes. First, it helps evaporate the remaining alcohol/water solution from under the edges, and second it makes the plastic more pliable so that it can contour to the edge of the light. Be careful if you are using a heat gun to warm the plastic. It takes only a small amount of heat to apply the material. If you apply too much heat you can damage the surface of the plastic.

"What if I want to remove the shields at a later date?"

The removal process is just a matter of warming the plastic, and peeling them off. They will require some muscle to get them off, but they normally peel off without any residue left on the lens. If any adhesive at all remains behind, it may be removed by simply rubbing it with your thumb. The adhesive will then ball up and roll off.
Mr.RonGilbert is offline  
 
 
For the best viewing experience please update your browser to Google Chrome