JKOwners Forum banner

3.8L Idler pully replacement?

8K views 8 replies 5 participants last post by  ezfriday 
#1 ·
I am looking to replace the idler pulley and was wondering if there are any after market idler pulleys that might offer any performance advantages over the stock pulley. The stock pulley has some wear on it that caused the serpentine belt to shred. Also I'm running a Hesco supercharger so I have an additional idler pulley with a longer serpentine belt ACDelco 6k1099.
 
#3 ·
Ok...

Thx for the tip ... I'll pm tkob1060...
 
#4 ·
#5 ·
Found one site

I did find one site so far with a variety of idler pulley options...

http://www.drivewire.com/search/?N=0&sv=0&VN=4294967114+4294962346+4294921689+4294962339+4294966818&Ntt=accessory+belt+idler+pulley&Nr=AND%28universal:0%29

Anyone with experience with any of these pulley's...

I'm considering the DAYCO no slack pully. Dayco has two pulleys... one standard and one a little more $ with a write up on better polymers, seals and such.

Here's the Dayco official site...

http://www.dayco.com.au/products.aspx?G=1787&P=1520
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top