Need help with trouble codes [Archive] - JKowners.com : Jeep Wrangler JK Forum

: Need help with trouble codes


mountain-man
01-01-2009, 05:38 PM
My check engine light came on today. I checked to see if there were any codes with my power programer. It came back with three. #1 is P0000, #2 is P0455, and #3 is B3004. Can anybody help me with the definition if these codes.

Thanks:

chromedome
01-01-2009, 05:59 PM
The only one of those I have on my list is...
P0455 ‐ Evap Purge System Large Leak

I don't show the other two, however
I have read out my codes and seen the P0000,
it did not trigger an engine light so I have reset it
without any issue.

Fishyguy
01-01-2009, 06:01 PM
P0000 usually means end of DTCs or No DTCs found

mountain-man
01-01-2009, 06:35 PM
Hey Chromedome , How are things. What was the large leak in you evap . We got alot of snow, I think that I ran over some large chunks of ice. My jeep was telling me that my gas cap was bad, then the check engine light came on. Hope I didnt screw anything up. I will get under there and check things out tomorrow.

Thanks:

mountain-man
01-01-2009, 06:42 PM
Anybody know what the B3004 DTC code is.

thanks:

WTF_LOL
01-01-2009, 06:50 PM
B should mean "body"

WTF_LOL
01-01-2009, 07:04 PM
If it helps at all, I had never seen "3" as te second character (usually 0 or 1) in the code so I did a little research


With Body codes, "2" is reserved for OEM use and "3" is reserved for SAE assignment.


"0" as the third character is SAE reserved for future use, lol

Basically, that is a F'ed up code to try and decifer.


P0455

p=Powertrain, 0=Generic, 4=Auxiliary Emission Controls, 55=indicates Evap system. So this can mean loose gas cap, Evap canister or other leak in the emesions system

I am guessing that (Body code) combined with the other codes is indicating the Evap canister is broken